Home Theater & Entertainment > General Discussion
Help with 4k blu Ray player and receiver
bigmike:
Hey guys,
So lets say I have a 4k tv and 4k blu ray player. But I have an older receiver that doesn’t support 4k or 7.1/7.2.
I have a Denon 590 receiver. For the time being can I somehow hook up just the audio to the receiver? Or do I need to get a whole new audio home theatre system too now?
Thanks for any suggestions and help
Steven11788:
If I am not mistaken it should still work, just a down downscale and not get full resolution. have you tried. Its can be frustrating. My tv and player has dolby vision but my receiver doesn't. So I have do player to tv, then player to receiver to decode the sound. I will say 4k systems are somewhat cheap now. I mean you can use same speakers
50s:
Video:
Your receiver wont support 4K video (only supports HDMI version 1.3a) so you'll need to connect the video from the bluray direct to the tv to view at full 4K.
If you do instead try to connect the video via bluray -> receiver -> TV, I am not sure if it will work, but best case it will only show at the old lower resolution standard of 2K, worst case not see anything or the picture colours are wrong.
Audio:
You can still use connect the bluray audio direct to the receiver and as Steven says the 7.1 / 7.2 will be automatically down-scaled to what you are used to hearing.
So to get the best effect as I describe above, that means you'll need to fiddle around with inputs:
- selecting the audio source on receiver as the bluray player
- and selecting the video source on tv being the bluray player.
That might get annoying over time until you upgrade the receiver to handle 4K video (minimum version HDMI 1.4 I believe) and cable both audio and video cables through it
bigmike:
Thanks for the input. I think I might just upgrade the set.
Steven11788:
I did and I wont again lol. I doubt 8k will really ever catch on. atmos is nice but super not needed. but 4k is IMO the final frontier
Navigation
[0] Message Index
[#] Next page
Go to full version